Related Manuals for Antec TPII-380
Summary of Contents for Antec TPII-380
- Page 1 power redefined User’s Manual Manuel de l’utilisateur / Anwenderhandbuch Manuale per l’operatore / Manual del usuario...
- Page 2 "Fan Only" connectors. If you need more cooling power than that, you can connect your case fans to the regular 4-pin peripheral connectors, but that setup won't be as quiet as our recommended setup. Note: Antec does NOT recommend connecting a CPU fan to the "Fan Only" connectors.
- Page 3 To measure the outputs accurately, the power supply must be turned on and have the minimum rated load attached to it. We recommend using Antec's ATX Power Supply Tester for this purpose. To test with a motherboard+CPU+RAM combination, please check your other equipment manuals and confirm that your setup meets the minimum rated load requirements.
- Page 4 To measure the +12V , +12V 1. Set the measuring dial of your meter to VDC. Choose a maximum measuring range of +20VDC or higher. 2. To measure the +12V output: Use a 4-pin Molex connector from the power supply and insert the positive pole (red) to the connector pin with the yellow wire.
- Page 5 Using TrueControl II-550: 1. The default voltages are set at +12V, +5V, and +3.3V. Turn the knob clockwise to increase output voltage and counterclockwise to decrease output voltage. The range within which you can adjust the voltage is ±5% of the specified output voltage (see Table 1). Note: Changing the output settings does not affect the voltage feedback circuitry, so if for example you set your +5V output to +5.2V, the power supply voltage feedback will operate to keep the +5V output as close to +5.2V as possible.
- Page 6 © Copyright 2005 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China. Antec, Inc. 47900 Fremont Blvd. Fremont, CA 94538 Tel: 510-770-1200 Fax: 510-770-1288 Antec Europe B.V.